2016 July Cisco Official New Released 300-370 Q&As in Lead2pass.com!
100% Free Download! 100% Pass Guaranteed!
Amazing,100% candidates have passed the 300-370 exam by practising the preparation material of Lead2pass, because the braindumps are the latest and cover every aspect of 300-370 exam. Download the braindumps for an undeniable success in 300-370 exam.
Following questions and answers are all new published by Cisco Official Exam Center: http://www.lead2pass.com/300-370.html
A company consists of two adjacent buildings, each with its own Cisco 5508 Wireless Controller with APs joined to the controller in the building. The two controllers are configured identically except for interface IP addresses. Only one SSID is being used in both buildings. The clients in building A are not experiencing any connectivity issues, but (he clients in building B report poor connections An engineer performs a site survey and finds co-channel interference, yet discovers mac Transmit Power Control was never performed on the APs and that Radio Resource Management is not functioning like it does in building A Furthermore, the controllers are in the same RF group and controller A is elected RF leader Which action will improve client connections in building B?
A. Ensure WMM is enabled on the SSID.
B. Manually select controller B as RF group leader.
C. Configure controller B to be in a separate RF group.
D. Doable the low data rates on the a radio and the b/g radio in building B.
You have successfully configured HA and SSO using two Cisco 5508 Wireless LAN Controllers. You are able to access the Active Primary WLC but are unable to access the Secondary Standby WLC. Which two methods will allow you to access the standby unit? (Choose two.)
A. Via SSH to the Redundancy Management Interface.
B. Via Service Port Interface.
C. Via SSH to the Management Interface.
D. Via console connection.
While reviewing CleanAir data in Cisco Prime Infrastructure, an engineer notices that a wideband jammer is not sending its Interferer Security Trap correctly. The engineer determines that the default seventy level has been changed. Which value does the engineer select to reset the seventy level to its factory setting?
Refer to the exhibit. An engineer is troubleshooting non-802 11 interference and observes this output. Which type of interference signatures can be identified?
A. one frequency hopping Bluetooth
B. two healthy CCK and one malformed OFDM
C. three broadband jammers
D. two strong microwave ovens and one moderate
Refer to the exhibit. An engineer is troubleshooting non-802.11 interference and observes the shown output. Which interference signature is the most harmful to Wi-Fi?
A. cordless phone
B. microwave oven
C. 2 4 GHz wideband jammer
D. FHSS Bluetooth
E. analog video camera
An engineer is deploying a wireless infrastructure and must use Layer 2 discovery for access point association. Which configuration meets this requirement?
A. Configure the Access Points and WLC management interface on the same VLAN.
B. Configure a DNS A RECORD to point to the controller.
C. Configure option 43 on The APs DHCP scope.
D. Configure the AP using a serial connection to indicate its controller.
In a cisco OfficeExtend environment, which encryption type n und between the access point and the mass LAW controller?
Which visual cue accurately describes a characteristic of the zone of impact displayed in Cisco Prime Infrastructure?
A. The closer the cirlce is to blue, the more localized the impact is.
B. The smaller the circle, the more localized the impact is.
C. The larger the circle, the more severe the impact is.
D. The more translucent the circle is, the more localized the impact is.
You can pass Cisco 300-370 exam if you get a complete hold of 300-370 braindumps in Lead2pass. What’s more, all the 300-370 Certification exam Q and As provided by Lead2pass are the latest.
2016 Cisco 300-370 exam dumps (All 70 Q&As) from Lead2pass:
http://www.lead2pass.com/300-370.html [100% Exam Pass Guaranteed!!!]