How to Pass Juniper JN0-696 Exam In First Try?

Juniper Networks Certified Support Professional (JNCSP-SEC): JN0-696 Exam
JN0-696 Questions & Answers
Exam Code: JN0-696
Exam Name: Juniper Networks Certified Support Professional (JNCSP-SEC)
Q & A: 40 Q&As

You want to allow remote users using PCs running Windows 7 to access the network using an
IPsec VPN. You implement a route-based hub-and-spoke VPN; however, users report that they
are not able to access the network. What is causing this problem?
A. The remote clients do not have proper licensing.
B. Hub-and-spoke VPNs cannot be route-based; they must be policy-based.
C. The remote clients’ OS is not supported.
D. Hub-and-spoke VPNs do not support remote client access; a dynamic VPN must be implemented instead.
Answer: B

Click the Exhibit button. Referring to the exhibit, PC-1 is unable to ping Server-1. Traffic from PC-
1 to Server-1 arrives on interface fe-0/0/3 but return traffic from Server-1 to PC-1 should be sent
out from interface fe- 0/0/2. What would you change on SRX-1 to resolve this problem?
A. Configure a security policy to allow traffic from the DMZ zone to the untrust-1 zone.
B. Configure a security policy to allow traffic from the DMZ zone to the untrust-2 zone.
C. Move both interface fe-0/0/2 and fe-0/0/3 to the same security zone.
D. Disable TCP SYN check and TCP sequence check.
Answer: C

You are having problems establishing an IPsec tunnel between two SRX Series devices. What
are two explanations for this problem? (Choose two.)
A. proposal mismatch
B. antivirus configuration
C. preshared key mismatch
D. TCP MSS clamping is disabled
Answer: BD

Two SRX Series devices are having problems establishing an IPsec VPN session. One of the
devices has a firewall filter applied to its gateway interface that rejects UDP traffic. What would
resolve the problem?
A. Disable the IKE Phase 1 part of the session establishment.
B. Disable the IKE Phase 2 part of the session establishment.
C. Change the configuration so that session establishment uses TCP.
D. Edit the firewall filter to allow UDP port 500.
Answer: A

Your SRX Series device has the following configuration:
[email protected]> show security policies

Policy: my-policy, State: enabled, Index: 5, Sequence number: 1 Source
addresses: any
Destination addresses: any
Applications: snmp
Action: reject
From zone: trust, To zone: untrust

When traffic matches my-policy, you want the device to silently drop the traffic; however, you
notice that the device is replying with ICMP unreachable messages instead. What is causing this
A. the snmp application
B. the reject action
C. the trust zone
D. the untrust zone
Answer: C

…go to to download the full version Q&As.